Pass Your NCM-MCI5.15 Exam Easily With 100% Exam Passing Guarantee [2022]
NCM-MCI5.15 Dumps are Available for Instant Access from Actual4test
NEW QUESTION 32
A Nutanix cluster is deployed with the following configuration:
* Three four-node blocks (A, B, and C)
* All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?
- A. VMs are migrated off of the nodes with disk failures.
- B. VM read and write operations continue normally.
- C. Each node with a failed disk is marked as degraded.
- D. VMs on the nodes with failed disks are unable to write data
Answer: B
Explanation:
Ref: https://next.nutanix.com/how-it-works-22/redundancy-factor-vs-replication-factor-37486
NEW QUESTION 33
An administrator is deploying several new application VMs to a Nutanix cluster. The application is very transactional with a 28/72 random, read/write ratio.
What should the administrator do?
- A. Add a minimum of four virtual disks to each VM, and aggregate them on guest OS level.
- B. Add one large SSD to each node and enable Flash Mode for the VMs.
- C. Add one large virtual disk to each VM. and use it for all application data.
- D. Add a minimum of four SSDs to each node to ensure all writes go to the SSDs.
Answer: A
Explanation:
Ref: https://next.nutanix.com/server-virtualization-27/iops-latency-issue-1168
NEW QUESTION 34
An administrator inherits a new Nutanix environment and logs in to a CVM to check the network configuration. The configuration is as follows:
Which action should the administrator take to improve network performance?
- A. Configure balance-sib or balance-tcp mode for br0-up if switch configuration allows
- B. Remove one 10 Gbs interface from br0-up to make sure all 10 Gbs can be used.
- C. Configure VLAN tagging both on br0 and br1 and their physical interfaces.
- D. Add eth0 and eth1 to the br0-up bond
Answer: A
NEW QUESTION 35
A new Nutanix cluster is ready for production on a remote site with no IT staff. Changes to the infrastructure will cost money and probably cause a cluster stop. The administrator needs to perform a health check on the environment that should include:
* Network connectivity checks
* Network performance status
* Storage performance status
Which tool should be used to perform this test?
- A. NCC
- B. X-Ray
- C. diagnostic, py
- D. clurator_cli
Answer: A
NEW QUESTION 36
A VM is exhibiting one or more of the following baseline values based on the past 30 days:
* CPU usage < 20%
* CPU ready time < 5%
* Memory usage < 50% (moderately) or < 20% (severely)
* Memory swap rate = 0 Kbps
Which type of VM is being described?
- A. Bully VM
- B. Constrained VM
- C. Over-Provisioned VM
- D. Inactive VM
Answer: C
Explanation:
NEW QUESTION 37
An organizations Nutanix Cluster is based on VMware vSphere. The cluster is configured to download software updates automatically. The administration needs to verify and eventually upgrade VMware hypervisor via Prism Ul.
After logging in to Prism, the administrator receives the message shown:
No available versions for upgrade
What is causing the current state?
- A. vSphere binaries need to be manually uploaded.
- B. The environment is running the latest vSphere version, so no update is required.
- C. The cluster is unable to connect to reIease-api.nutanix-ccm:8D.
- D. VMware support has expired, so downloads are not available.
Answer: B
Explanation:
ref: https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:upg-hypervisor-upgrade-esxi-c.html
NEW QUESTION 38
An administrator needs to expand a cluster based on AHV and running on Nutanix G5 hardware with a new Nutanix G7 system. The cluster is running AOS 5.10 but the operation fails when expanding the cluster. AOS is running on the new system. There are no issues discovering the node.
Why is the operation failing?
- A. EVC needs to be configured before cluster expansion
- B. G7 hardware cannot be added to a G5 cluster.
- C. AOS version running on G7 is older than the version on the cluster.
- D. Foundation software has not been updated on the cluster.
Answer: C
Explanation:
Ref: https://next.nutanix.com/installation-configuration-23/product-mixing-restrictions-37231
NEW QUESTION 39
An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins. Which method should the administrator use to access the cluster in the event of this type of outage?
- A. Deploy an Active Directory server locally on the cluster
- B. Manage the cluster by using the "nutanix" user on the Prism leader CVM
- C. Create and use an emergency local account on the cluster
- D. Manage the cluster remotely by downloading ncli to a remote workstation
Answer: C
NEW QUESTION 40
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)
Answer:
Explanation:
Explanation:
1 allow vms 2 sd CVM 3 sd node
NEW QUESTION 41
A customer wants to run SAP HANA on a Nutanix cluster with the following characteristics:
* AHV nodes
* SAP HANA version 2
* Production database files
Which configuration should be recommended to the customer?
- A. Do not enable compression, deduplication. or erasure coding on the storage container
- B. Enable only compression for the container that contains the Production database
- C. Plate the SAP HANA Database on the same socket as CVM
- D. Start with a cluster containing three or more nodes
Answer: A
Explanation:
Ref:
NEW QUESTION 42
An administrator needs to evaluate if the existing configuration of Protection Domains meets the specified corporate recovery policy for SQL Data. The corporate policy requires that all SQL Servers be recoverable at the DR site within 30 minutes, and must result in a maximum of 60 minutes of data loss. SQL data must be required.
The protection domain is configured as follows:
* Application consistent snapshots are enabled
* The SQL server VMs are assigned to the Protection Domain as their own Consistency Group
* The Protection Domain schedule is configured as snapshots taken every 90 minutes from 7 am until 8 pm What must be changed to meet the required policy?
- A. Revise the schedule to be 30 minutes
- B. Revise the schedule to be 45 minutes
- C. Revise the schedule tc be 15 minutes
- D. Revise the schedule to be 60 minutes
Answer: D
NEW QUESTION 43
An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:
* 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks
* Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)
* Current cluster utilization is 500TB storage
* Storage containers have Erasure Coding enabled
Which configuration changes should be made to make sure the cluster meets the requirements?
- A. Expand the cluster to 50 nodes distributed evenly across 5 racks
- B. Expand the cluster to 48 nodes distributed evenly across 6 racks
- C. Expand the cluster to 60 nodes distributed evenly across 6 racks
- D. Expand the cluster to 40 nodes distributed evenly across 5 racks
Answer: C
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v5_17:arc-configure-fault-tolerance-rack-prism-c.html
NEW QUESTION 44
A customer has a four-node cluster and is using Volume Groups to provide storage services to a SQL cluster.
In the event of a CVM failure in the cluster, what is the expected IO path of the volume group's iSCSI targets?
- A. vDisk directed at failure CVM are redirected to Data Services IP until CVM is reconnected
- B. vDisk directed to failed CVM are redirected to another CVM and automatically reconnect
- C. vDisk directed at failed CVM will disconnect and reconnect when the failed CVM comes back online
- D. vDisk directed to CVM that failed to disconnect and will not reconnect without manual intervention
Answer: B
NEW QUESTION 45
Refer to the exhibit.
User 1 and User 2 belong to the AAPM group
What are two descriptions of how Files perform quota management? (Choose two.)
- A. User 2 can continue to add another 3GB file but will receive a daily notification email.
- B. User 1 can add an 8GB file to the share without receiving notification.
- C. User 2 can add an 8GB file without receiving a notification email.
- D. User 1 can continue to add another 5GB file but will receive a daily notification email.
Answer: C,D
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-file-server-quotas-c.html#nconcept_amp_xsm_bx
NEW QUESTION 46
An administrator is migrating 5MB shares from a third-party platform to Nutanix Files with the following characteristics:
* Shares contain user profile directories
* DFS-N will be used
How should the administrator create target shares for this migration?
- A. Create distributed shares with multiple top-level directories and distribute migrated data.
- B. Create multiple distributed shares and distribute migrated data as evenly as possible.
- C. Create standard shares with multiple top-level directories and distribute migrated data.
- D. Create multiple general purpose shares and distribute migrated data as evenly as possible.
Answer: A
Explanation:
Ref: https://portal.nutanix.com/page/documents/details/?targetId=Files-v3_6:Files-v3_6
NEW QUESTION 47
An administrator needs to deploy an application with a large amount of data connected via Nutanix Volumes.
Which two actions should the administrator take when designing the Volume Group? (Choose two.)
- A. Enable thick provisioning on the Volume Group(s)
- B. Use multiple subnets for iSCSI traffic
- C. Enable RSS (Receive Side Scaling)
- D. Distribute workload across multiple virtual disks
Answer: C,D
Explanation:
NEW QUESTION 48
An administrator needs to maximize storage potential in a six-node cluster. The container is configured with the following:
Post-process compression
Capacity deduplication
What should the administrator configure to increase space savings?
- A. Reserve capacity
- B. Inline compression
- C. Erasure coding
- D. Cache dedupe
Answer: C
NEW QUESTION 49
A company needs to replicate their VMs to a remote site and must have an RPO of less than 1 hour.
When creating a protection domain, what should an administrator do to meet this requirement?
- A. Enable Near-Sync Replication with an RPO of 15 minutes
- B. Enable Async Replication with an RPO of 60 minutes
- C. Enable Entity Sync on the designated VMs
- D. Enable Availability Zones and send the VM to multiple targets
Answer: B
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v5_10:sto-pd-guidelines-r.html
NEW QUESTION 50
An administrator finds that home shares cannot be configured in a new Files 3.5 deployment. Why is this happening?
- A. NFS default access is set to Read Only.
- B. Multi-protocol access is not configured.
- C. Access Based Enumeration is not enabled.
- D. The system is deployed as a single FSVM.
Answer: D
Explanation:
NEW QUESTION 51
Refer to the exhibit.
An administrator is commissioning a Nutanix Enterprise Cloud. Once the user VMs have been deployed and are running, the administrator finds that VMs on the same host are able to communicate, but are unable to communicate between hosts.
What must be changed to enable full inter-VM communications?
- A. Change the spanning-tree port type on the switch
- B. The VMs need to have static IP addresses
- C. Update the switch to specifically allow VLAN 15
- D. Change the network the VMs are connected to
Answer: C
Explanation:
Ref: https://hyperhci.com/2019/11/09/nutanix-ahv-enable-vlan-trunk-mode-on-guest-vm/
NEW QUESTION 52
Refer to the exhibit.
An administrator notices a critical alert on the Metro Availability Protection Domain What is causing this alert?
- A. vSphere moved VMs to the remote container, and the VMs must be moved back.
- B. VMware Site Recovery Manager is handling a failover event
- C. Metro Availability Protection domain is active on the remote site.
- D. Metro Availability did not fail over and caused an outage.
Answer: C
Explanation:
Ref: https://www.vvlsystems.com/wp-content/uploads/2016/11/BP-2009_Metro_Availability.pdf
NEW QUESTION 53
While creating an image placement policy on the organizations AOS 5.15-based Nutanix cluster, the administrator wants to ensure there are no restrictions on using the selected images on clusters outside of the identified set.
What type of Policy Enforcement must the administrator choose?
- A. Soft
- B. Internal
- C. Hard
- D. External
Answer: A
Explanation:
NEW QUESTION 54
An organization is running a Nutanix Cluster based on AOS 5.10.x and VMware vSphere 6.7. Currently, the CVM network is segmented and Storage only nodes not present.
A new security project based on NSX is coming. VMware Distributed Virtual Switches are required. The administrator needs to prepare the environment for the new project.
Which step should the administrator use to initiate the project?
- A. Manually disable CVM network Segmentation
- B. Enable Nutanix Flow at the Prism Central Level
- C. Enable Jumbo Frames to accommodate network frames
- D. Convert storage only nodes into vSphere nodes
Answer: C
NEW QUESTION 55
An administrator responsible for a VDI environment needs to investigate reports of slow logins. The administrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count on all of the VDI VMs.
What are two impacts on the cluster? (Choose two.)
- A. Increase CPU utilization%
- B. Increase CPU ready%
- C. Increase memory utilization%
- D. Increasing CPU counts will decrease memory utilization
Answer: A,B
NEW QUESTION 56
......
Study resources for the Valid NCM-MCI5.15 Braindumps: https://pdftorrent.actual4test.com/NCM-MCI5.15_examcollection.html