CTTAM Civil-Engineering-Technology Actual Tests : Technical Examination - Civil Engineering Technology C.E.T

CTTAM Civil-Engineering-Technology Exam Syllabus Topics:

CTTAM Technical Examination - Civil Engineering Technology C.E.T Sample Questions:

1. In which step in this diagram will a general contractor need to consider their bonding capacity?

A) Notify subcontractors
B) Complete bid report
C) Decision to bid
D) Management review

2. Why is it important to keep daily site diaries and inspection data, such as sketches, notes, and photos?

A) To support monthly invoices
B) To document daily activities on a construction site
C) To justify monthly expenses on a construction site
D) To justify daily expenses on a construction site

3. In an oil and gas project, the location of a pile is offset by 78 mm north and 54 mm east of the key location plan. The location was stamped and issued for construction by a consulting engineering company. The statement on the drawings says, "Offset more than 75 mm is not accepted." Which of the following is the best approach for the civil engineering technologist to take?

A) Inquire with the client if the pile location is acceptable.
B) Accept the pile location as is because the offsets are close enough to 100 mm.
C) Submit a non-conformance report to the design engineer for review and advice.
D) Fill up the hole and re-drill the pile hole based on the pile key location plan.

4. Typically, what is the maximum time that concrete can be in a mixer truck before it is discharged?

A) Under 2 hours
B) 2-3 hours
C) Over 4 hours
D) 3-4 hours

5. A civil engineering technologist asked an engineer in training (EIT) to write a deficiency report. After a few revisions, the report is still disorganized and has errors. What would be an appropriate action to take for the technologist?

A) Explain to the EIT the importance of meeting deadlines.
B) Complete the document on behalf of the EIT.
C) Report the EIT to the supervisor and recommend training.
D) Assist the EIT in re-writing the report.

Solutions: